Compared with other forms of steeringrs, the gear rack -type steering gear structure is simple and compact; the shells are mostly made of aluminum alloy or magnesium alloy die -casting, and the quality of the steeringrs is relatively small; After the gap between the gears and the gear rack, the springs that can be adjusted can be adjusted by using the tightening force installed on the back of the gear and near the active small gear. This can automatically eliminate the gap. Increases and noise at work; the steering device occupies a small volume; there is no steering rocker and straight tie rods, so the steering wheel rotor corner can be increased and the manufacturing cost is low.
However, its reverse efficiency is high. When the car is driving on the road surface, most of the impact between the steering wheel and the pavement can be transmitted to the steering wheel, causing the driver to be nervous. Sudden rotation of the plate will cause thugs, and at the same time hurt the driver.